3M PELTOR LiteCom Plus MT7H7A4610-NA Manual De Instrucciones página 12

EN
Power (radio transmitter)
The Power feature controls the power level of the radio transmitter. There are two output power levels, low and high. The
low setting will reduce the communication range but will increase the battery life. Press the (+) button (A:11) or (–) button
(A:12) to set the level.
Language
The audio menu can be spoken in either English, French or Spanish. Press the (+) button (A:11) or (–) button (A:12) to set
the language.
Set up menu
The set up menu gives you access to the following advanced settings for the headset. To access this menu, ensure the
headset is powered off and then press the PTT auxiliary button (A:16) and the On/Off/Mode button (A:10) simultaneously.
To exit the set up menu, press and hold the On/Off/Mode button (A:10) for 2 seconds to power off the headset.
Busy channel lockout (BCLO)
By default, the BCLO feature will prevent VOX transmission on a carrier signal when the channel is busy and you will hear
an audible tone to indicate the blocked transmission.
You can set the BCLO feature to react to either "carrier" or "sub channel" communication, as well as choose whether or not
you want to hear a warning tone when your transmission is blocked. The BCLO feature can also be disabled. Press the (+)
button (A:11) or (–) button (A:12) to select the BCLO setting.
Max transmission time
This feature lets you adjust the maximum continuous transmission time. Choose a time frame between 30 seconds and 5
minutes, or disable this feature for an unlimited transmission time. Press the (+) button (A:11) or (–) button (A:12) to adjust
the maximum transmission time.
Automatic power off
This feature allows you to determine the period of time (from the last button press or VOX transmission) that the headset
will automatically power off. The default setting is two hours. Press the (+) button (A:11) or (–) button (A:12) to choose a
time frame between 30 minutes and eight hours, or disable this feature so the headset will not automatically power off (until
the batteries are depleted).
External mode
The external mode feature allows the user to configure the headset to function with different types of auxiliary equipment
(connected via the auxiliary port (A:17). The default setting is the external PTT mode. Press the (+) button (A:11) or (–)
button (A:12) to change this setting to input source mode (e.g. FM/AM radio), phone mode (e.g. mobile phone or DECT
phone) or radio mode (external communication radio).
Microphone input
By default, the LiteCom Plus headset is supplied with a dynamic microphone (MT7), but it can be configured to use an
electret microphone (MT53) instead. Press the (+) button (A:11) or (–) button (A:12) to select the microphone type, or dis-
able the microphone altogether to configure the headset as a listen-only device.
Microphone mute (to the external output)
When using the built-in communication radio, by default the sound from the speech microphone is not routed to the exter-
nal output. This menu setting allows you to route the sound to the external output. Press the (+) button (A:11) or (–) button
(A:12) to switch this function on or off.
External jack level control
This function permits automatic level control for the incoming signal from auxiliary equipment. Press the (+) button (A:11) or
(–) button (A:12) to switch this function on or off.
Menu return
By default, this feature is off, and the headset will always remain on the last chosen menu item. Turn this feature on and
the headset will always return to the first menu item (Surround) after a seven second period of inactivity. Press the (+)
button (A:11) or (–) button (A:12) to choose the desired setting.
10