Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Grinding tools that are listed in
these operating instructions can
be used.
The grinding tools (grinding
and cutting discs of artificial
resin bonded, fibre laminated
material) must be qualified for
the following minimum rota-
tions per minute/maximum cir-
cumferential speed.
Always observe the allowable
rotational/circumferential
speed on the label of the
grinding tools!
Always disconnect the plug from the power socket before carrying out
any work on the appliance.
Always disconnect the plug from the power socket before carrying out
any work on the appliance.
Always keep the machine and the ventilation slots clean for proper and
safe working.
In extreme working conditions, conductive dust can accumulate in the
interior of the machine when working with metal. The protective insula-
tion of the machine can be degraded. The use of a stationary extraction
system is recommended in such cases as well as the frequent blowing
out of the ventilation slots and the installation of a residual current cir-
cuit breaker.
If the machine should happen to fail despite the care taken in manufacture and
testing, repair should be carried out by an authorised customer services agent
for Würth power tools.
For all correspondence and spare parts orders, always include the 9 digit order
number of the machine!
Allowable Grinding Tools
Rotating the Machine Head
The machine head can be turned on the motor
housing in 90° degree steps. In this manner, the
on-off switch can be brought into a favourable
handling position for special working situations.
Unscrew the four screws.
Rotate the head to the new position without re-
moving from the housing.
Screw in the screws again and tighten.
Care and Maintenance
d
115 6
D
b
D
125 -
d
b
D
max.
[mm]
[mm]
D
b
d
22 11 000
-
11 000
75 30 M14 11 000
RPM
m/sec
80
80
45
Publicidad
Tabla de contenido
