Complete The Installation - Heath Zenith DualBrite ENERGY STAR Instrucciones De Instalación

COMPLETE THE
INSTALLATION
❒ Stuff the wires into the junction box.
Make sure the wires from the fixture go
through the wire path, and no wires get
pinched.
Controls facing
downward
Slide the fixture onto the mounting
screws and tighten nuts.
❒ Caulk fixture mounting surface with
silicone weather sealant. You may want
to wait until you have completed the tests
and adjustments on pages 4 and 5.
❒ Install one 100 Watt max. light bulb.
598-1283-02
TESTING
❒ Turn on the circuit breaker and light
switch.
NOTE: Sensor has a 1
period before it will detect motion.
When first turned on or when
switching modes wait 1
❒ Switch the on-time to TEST position and
D B switch to the off position.
®
ual rite
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objectsreflect-
ing daylight may trigger the shut-off feature.
Do not point other lights at the sensor.
5
/ minute warm up
1
2
/ minutes.
1
2
OFF 3 6 DUSK TO
HOUR DAWN