GreenWorks GN 220 Manual Del Operador página 23

MAINTENANCE
REPLACING THE SCRAPER (See Figure 10)
W A R N I N G
Make sure to turn off the bail lever and remove the battery pack(s) before performing any
maintenance task on your snow thrower.
NOTE: The scraper is located at the bottom of the impeller housing. Ensure that the battery is
not installed in the tool.
• Turn the machine to its side.
• Remove the 5 bolts (2) below the deck that attach the scraper to the machine.
• Remove the worn scraper (1) from the machine.
• Install the new scraper.
• Install and tighten the bolts that you removed.
2
1
Fig. 10
22