Skoda BEA 800 003 Instrucciones De Montaje página 18

Idiomas disponibles

PARK DISTANCE CONTROL

The accessories are intended for professional assembly. Škoda Auto recommends

that the assembly should be performed by a contracted partner.

− The park distance control order no. BEA 800 003 is intended for the model ŠkodaSuperb

Combi (3T9) to facilitate reversing. The four sensors in the rear bumper monitor the

distance between the vehicle and any possible obstacle. The driver is informed of the

extent of the free area by an acoustic signal from the loudspeaker.

− If an obstacle is encountered at a distance of approx. 160 cm from the rear section

of the vehicle it is signaled with short beeps at 1 second intervals. On approaching

the obstacle this interval will become increasingly shorter. At a distance of approx.

30 cm the beeping will change to an uninterrupted tone (STOP signal) and will be

accompanied by changes in pitch, Ref. individual zones, Fig. 11.

− The park distance control is not connected to data lines and therefore diagnostics

cannot be performed by the VAS instrument and also it will not allow the transmission

of information to other components in the vehicle (e.g. car radio display).

List of parts in the set (Fig.1)

Name of part

Control unit

Loudspeaker with cables

Cables

Sensor holder

Sensor

Hole poker

Painting template

Control unit felt padding

Self-adhesive tape

Large self-adhesive tape

Tightening band

Tightening band with clip

Additional wires

Disassemble and reassemble the individual parts in accordance with the workshop

manuals. The car battery must be disconnected during assembly.

Disassemble the rear bumper spoiler (Note: if a diffuser is attached to the vehicle then

disassemble the entire bumper.) Then remove the luggage compartment sill panel and

the D-column lining on the right hand side of the vehicle. Disassemble the right side panel

of the luggage compartment lining so it is sufficiently uncovered or remove it completely.

Carefully clean and degrease all of the places selected for affixing the park sensor

Amount

Position