Steelcase Bivi Serie Manual De Instrucciones página 5

®
Attach Leg to Trough
TROUGH IS TO BE CENTERED
IN ORDER TO CORRECTLY CONSTRUCT TABLE,
TROUGH MUST BE EXACTLY CENTERED
TIP:
Rest one side of the trough on the floor
and place lip on the other side into the bottom
edge of the leg.
NOTE: For the "Table for One", place the trough
to the far end, see page 9.
3.
Stand one leg up. Lift and place end of
trough up to the leg. Drop the lip of the trough onto
the rib on the leg (3a). Make sure the connection
bracket is fully engaged with the top leg rib (3b).
Tighten with hex wrench to 55-70 in-lbs (6.2-8 Nm) (3c).
3a
LIP
RIB
CONNECTION
BRACKET
NOTE: You must loosen connection
bracket prior to install
TROUGH
TOP LEG RIB
3b
View from Underneath
TROUGH
LEG
HEX WRENCH
3c
Page 5 of 11
P/N 1059580001
Doc # 70525 Rev E