Seca 703 Manual De Instrucciones Y Garantía página 62

Malfunction
... is displayed?
... if after switch-on,
measured results are
transmitted for the first
time and two acoustic
signals are heard?
... only the item "SYS" is
visible in the rF menu?
... only the items "SYS"
and "Lrn" are visible in
the rF menu?
... the items "APrt" and
"tIME" are not visible in
the rF menu?
Er:X:11
... is displayed?
Er:X:12
... is displayed?
Cause/Remedy
The ambient temperature of the scales is too high
or too low.
- Set up scales in an ambient temperature
between +10 °C and +40 °C
- Wait approx. 15 minutes until scales have
adjusted to ambient temperature
• The device was unable to send measured
results to the radio receiver (seca wireless
printer or PC with seca USB wireless module).
– Check that the scales are integrated in
the wireless network.
– Check that the receiver is switched on.
• Nearby RF equipment (e.g. mobile phones) are
interfering with reception.
- Make sure that RF equipment is kept at least
1 metre away from transmitters and receivers
in the seca wireless network.
NOTE:
If such interference is not eliminated, no
further acoustic warning will be given with
subsequent attempts at transmission.
• The wireless module is disabled.
- Activate wireless module (see "Activate wire-
less module (SYS)" on page 56).
• The wireless module is activated but no
wireless group set up.
- Set up wireless group (see "Set up wireless
group (Lrn)" on page 56).
• No wireless printer is logged into the wireless
group.
- Use menu item "Lrn" to log the wireless
printer into the wireless group(see "Set up
wireless group (Lrn)" on page 56).
The scales are too high, or too great a load is
applied at one point.
- Reduce load on scales or distribute weight-
more evenly
- Restart scales
The scales have been switched on with too great
a load.
- Reduce load on scales
- Restart scales
English
What to do if ...? • 61