Working Advice - Bosch PLR 25 Manual Del Usuario

26 | English
Subtracting Measured Values
Push the memory subtraction button 3 in order to subtract the
current measured value from the memory value. As soon as a
value has been subtracted, "M" is indicated in the display and
the "–" behind it briefly flashes.
If a value is already stored in the memory, the new measured
value can be subtracted only when the measures of unit corre-
spond (see "Storing/Adding Measured Values").
Displaying the Stored Value
Deleting the Memory
To delete the memory contents, first push the memory retrieve
button 11, so that "M=" is indicated in the display. Then briefly
press button 1; "M" is no longer indicated in the display.

Working Advice

General Information
The reception lens 17 and the laser beam outlet 16 must not
be covered when taking a measurement.
The measuring tool must not be moved while taking a measure-
ment (with the exception of the continuous measurement
function). Therefore, place the measuring tool, as far as this is
possible, against or on the measuring points.
Measurement takes place at the centre of the laser beam, even
when target surfaces are sighted at an incline.
Influence Effects on the Measuring Range
The measuring range depends upon the light conditions and
the reflection properties of the target surface. For improved
visibility of the laser beam when working outdoors and when
the sunlight is intense, use the laser viewing glasses 19 (acces-
sory) and the laser target plate 20 (accessory), or shade off the
target surface.
2 609 140 620 | (24.4.09)
Push the memory retrieve button 11 in
order to display the value stored in the
memory. "M=" is indicated in the display.
When the memory contents "M=" is indi-
cated in the display, it can be doubled by
pushing the memory add button 4 or set
to zero by pushing the memory subtract
button 3.
Bosch Power Tools