Porter Cable PCC661 Manual Del Usuario página 11

• Move the saw shoe into the desired
position. The corresponding depth of cut
can be read from the scale (14).
• Set depth adjustment of saw such that
one tooth (15) of the blade projects below
the workpiece (16) as shown in figure I.
• Tighten the knob to lock the saw shoe in
place.
H
11
I
16
Bevel ANGle AdjuSTMeNT -
fIGuRe j
This tool can be set to bevel angles between
0° and 50°.
• Loosen the bevel adjustment knob (10)
to unlock the saw shoe (5).
• Move the saw shoe (5) into the desired
position. The corresponding bevel angle can
be read from the scale (17).
• Tighten the bevel adjustment knob (10)
to lock the saw shoe in place.
• Confirm the accuracy of the setting by
checking the bevel angle of an actual cut on
a scrap piece of material.
j
10
17
SHoe AdjuSTMeNT foR 90° cuTS
The shoe (5) has been set by the factory to
assure that the blade is perpendicular to the
shoe at 0° bevel setting.
5
14
15
18b
18a
5
IF rEALIGNMENT IS NEEDED:
• Adjust the saw to 0° bevel.
• retract blade guard (8).
• Loosen bevel adjustment knob (10). Place a
square against the blade (7) and shoe (5) to
adjust the 90° setting.
• Loosen jam nut (18a) and move the
adjustment screw (18b) (inset figure j)
so that the shoe will stop at the proper
angle. Retighten jam nut against the
shoe while holding adjustment screw in
position.
• Confirm the accuracy of the setting by
checking the squareness of an actual cut
on a scrap piece of material.
ATTAcHING ANd ReMovING THe
BlAde - fIGuRe k - l
• retract lower guard and assemble blade
(7) and clamp washer (19) as shown in
figure k.
• Depress the spindle lock (13) while
turning the blade bolt (20) with the blade
wrench (9) until the blade lock engages
and the blade stops rotating.
NoTe: Blade wrench is stored on the
saw as shown in figure l.
• Tighten the blade bolt securely with the
blade wrench.
NoTe: Bolt has a left-handed thread. To
loosen, turn clockwise. To tighten, turn
counterclockwise.
NoTe: Never engage the blade lock while
the saw is running, or engage in an effort
to stop the tool. Never turn the tool on
while the blade lock is engaged. Serious
damage to your saw will result.
k
l
11
13
20
7
19
9