Porter Cable PCC661 Manual Del Usuario página 13

• Adjust the shoe (5) so the blade cuts at
desired depth.
• Tilt the saw forward and rest front of the
shoe on material to be cut.
• Using the retracting lever, retract lower
blade guard to an upward position. Lower
rear of shoe until blade teeth almost
touch cutting line.
• release the blade guard (its contact with
the work will keep it in position to open
freely as you start the cut). Remove
hand from guard lever and firmly grip
secondary handle (4), as shown in figure
M. Position your body and arm to allow
you to resist kickback if it occurs.
• Make sure blade is not in contact with
cutting surface before starting saw.
• Start the motor, allow saw to come to full
speed, and then gradually lower the saw
until its shoe rests flat on the material to be
cut. Advance saw along the cutting line until
cut is completed as shown in figure M.
• release trigger and allow blade to stop
completely before withdrawing the blade
from the material.
• When starting each new cut, repeat as above.
M
MAINTeNANce
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
IMPoRTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed
by authorized service centers or other
qualified service personnel, always using
identical replacement parts.
AcceSSoRIeS
Recommended accessories for use with
your tool are available from your local
dealer or authorized service center. If you
need assistance regarding accessories,
please call:
1-800-544-6986.
WARNING:
The use of any accessory
not recommended for use with this tool
could be hazardous.
RBRc SeAl
TM
The RBRC™ (Rechargeable Battery
Recycling Corporation) Seal on the
lithium-ion battery (or battery pack)
indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life
have already been paid by Porter Cable.
In some areas, it is illegal to place spent
lithium-ion batteries in the trash or municipal
solid waste stream and the RBRC program
provides an environmentally conscious
alternative.
RBRC in cooperation with Porter Cable
and other battery users, has established
programs in the United States and
Canada to facilitate the collection of
spent lithium-ion batteries. Help protect
our environment and conserve natural
resources by returning the tool to an
authorized Porter Cable service center
for recycling. You may also contact your
local recycling center for information on
where to drop off the spent battery, or call
1-800-8-BATTeRy.
This Class B digital apparatus complies
with Canadian ICES-003. This device
complies with part 15 of the FCC rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NoTe: This equipment has been tested and
found to comply with the limits for Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
13