Installing The Alignment Jig En - Binzel ABIROB G350 Instrucciones De Servicio

Alignment jig
5.1 Installing the alignment jig
NOTICE
• To allow the alignment jig to be screwed on without distortion, the installation surface must be flat and
13
12
11
10
9
8
7
6
5
1 Clamping body
2 G350 gauging sleeve
3 Adjusting lever and fastener
4 Mounting plate
5 Complete guide body with inspection device
Fig. 1 Installing the alignment jig
1 Use M8 screws to attach the alignment jig to the bores (13) on a flat surface. (The 6 screws are not
included with the jig)
2 Mount the guide body (5) in line with the bending angle to be checked and the clamping body (1) on
the mounting plate (4).
The device has been designed so that all bending angles of a torch series can be tested in one clamping
process using additionally screwed on guide bodies. For special torches, the alignment jig is customized.
should ideally be dry and free from dirt.
6 G350 setting sleeve
7 G500 gauging sleeve
8 G360 gauging sleeve
9 G360 adaptor
5 Functional description
1
2
3
4
10 G500 adaptor
11 G360 setting sleeve
12 G500 setting sleeve
ø
13 Bore 9 (6x)
EN - 7