Troubleshooting; Disassembly; Disposal; Materials - Binzel ABIROB G350 Instrucciones De Servicio

Alignment jig

8 Troubleshooting

NOTICE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding components, such as the power source,
Fault
The test block jams and does not
automatically return to the basic
position
The torch does not fit into the
clamping body
Tab. 9

9 Disassembly

NOTICE
• Disassembly must only be carried out by qualified personnel (in Germany see TRBS 1203).

10 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. To correctly dispose of the product, it must first be disassembled.
Please take note of the following information:
 9 Disassembly on page EN-11

10.1 Materials

This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labelled in preparation for their sorting and
separation for later recycling.

10.2 Consumables

Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions in the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the consumables' manufacturer.

10.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
welding torch system, etc.
Cause
• Spring broken
• Test block dirty
• Clamping body dirty
Troubleshooting
8 Troubleshooting
Troubleshooting
• Replace the spring
• Clean the test block
• Basic cleaning
EN - 11