Adjusting The Bending Angle; Maintenance And Cleaning; Monthly - Binzel ABIROB G350 Instrucciones De Servicio

7 Maintenance and cleaning

6.2 Adjusting the bending angle

Material damage
Too frequent and excessive bending can destroy the torch neck.
• Only make minor corrections.
1
1
2
Fig. 5
1 Plug/screw the setting sleeve (3) onto/into the gas nozzle receptacle.
2 Put the adjusting lever (4) onto the setting sleeve (3) and correct the bending angle slightly.
During this process, continually check the concentricity of the test mandrel (1) and gauging sleeve (2).
The bending angle is correct if the test mandrel (1) fits easily into the bore of the gauging sleeve (2).
7 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.

7.1 Monthly

Monthly basic cleaning is recommended, and necessary in case of extreme working conditions.
EN - 10
CAUTION
Test mandrel
Gauging sleeve
Adjusting
2 3
3 Setting sleeve
4 Adjusting lever
Alignment jig
4