Important Safety Instructions - SEVERIN WL 0801 Manual Del Usuario

GB
Hair-styling-Set
Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the appliance.
This product complies with the directives which
are binding for the CE-labelling.
Familiarisation
1. Indicator light
2. 4-position switch
3. Power cord with swivel and hanging loop
4. Air inlet openings
5. Styling nozzle
6. Round brush (Ø 20 mm)
7. Ceramic round brush (Ø 32 mm)
8. Air outlet opening
9. Lock/release button

Important safety instructions

■
Caution! Do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin filled
with water or any other receptacle
containing water.
■
There is always a risk when the appliance is
operated near water even when it is
switched off. Therefore, if the appliance is
being used in a bathroom always remove
the plug from the wall socket after use.
Additional protection is offered by fitting an
earth-leakage circuit-breaker with a rated
tripping current not exceeding 30mA into
your bathroom installation. Please consult a
qualified electrician.
■
Protect the appliance from moisture and
splashing water and do not operate it with
wet hands.
■
Electric heating appliances operate at very
high temperatures. Do not touch any part of
the appliance except the housing. Burns
can occur from touching the hot parts.
■
Do not use the appliance on synthetic hair-
pieces or wigs. The heat emitted might
cause damage to the synthetic fibres.
■
Make sure the air intake and outlet
openings are not blocked by fingers or hair
and that no lint particles are allowed to
accumulate in the air intake.
■
Should the unit automatically switch off
during use, the integral overheating
protective device may have been activated.
The appliance will switch on again after a
sufficient cooling down period.
■
Before the appliance is used, the main
body as well as any attachment fitted
should be checked thoroughly for any
defects. Should the appliance, for instance,
have been dropped onto a hard surface, it
must not be used any longer: even invisible
damage may have adverse effects on the
operational safety of the appliance.
■
Do not leave the appliance unattended
while in use.
■
To prevent damage to the power cord,
- do not bend or kink the cable, especially
where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
■
Do not place the appliance on any surface
sensitive to heat during or immediately after
use.
■
Do not operate the appliance if it is stored
on the hanging loop.
■
Make sure hot attachments are kept away
from the scalp.
■
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
■
Always switch off and remove the
plug from the wall socket after use,
and also
9