MOVING YOUR UNIT
Hold the unit around its sides or base when moving it. Under no circumstances, it should be lifted
by holding the edges of the top surface
The appliance should be transported only in a vertical upright position. The packing as
supplied must be intact during transportation. If during the course of transport the product
has been transported horizontally, it must only be laid on its left hand side (when facing the
door front) and it must not be operated for at least 2 hours to allow the system to settle
after the appliance is brought back to upright position.
1.
Failure to comply with the above instructions could result in damage occurring to the
appliance. The manufacturer will not be held responsible if these instructions are
disregarded.
2.
The appliance must be protected against rain, moisture and other atmospheric influences.
INSTALLATION INSTRUCTIONS
1.
If possible avoid placing the appliance near cookers, radiators or in direct sunlight as
this will cause the compressor to run for long periods.
2.
Make sure that sufficient room, with an average temperature of between 16°C and
32°C, is provided around the appliance to ensure free air circulation. Ideally, a space
of no less than 10cm on the back, 10cm on the sides and 30 cm on the top of the
unit should be left.
3.
The appliance should be located on a smooth surface.
4.
It is forbidden to use the refrigerator outdoors.
Door Space Requirements
The unit's door must be able to open fully as shown. Spare enough space for
convenient opening of the doors and drawers.
W×D≥902×1052mm
Leveling the Unit
To do this, adjust the two leveling feet at the front of the unit. If the unit is not
level, the door and magnetic seal alignments will not be covered properly.
Make sure that the foot touches the ground before use.
Adjusting procedures:
a.
Turn the feet clockwise to raise the refrigerator;
b.
Turn the feet counterclockwise to lower the refrigerator;
c.
Adjust the right and left feet based on the procedures above to a horizontal level
STARTING TO USE
Before you starting to use the freezer, please check that:
1.
The interior is dry and air can circulate freely at the rear.
2.
Clean the interior as recommended under "TAKE CARE" section (electric
parts of the refrigerator can only be wiped by dry cloth).
3.
Do not switch on until 2 hours after moving the fridge/freezer.
4.
Before connecting the refrigerator check that the socket is compatible with the
plug supplied with the unit
13