Further Safety Directions; Assembly - Deltafox DG-ECS 7120 T Traducción Del Manual De Instrucciones Origina

a
Bild 1
• Kickback may occur when the nose
or tip of the guide bar touches an ob-
ject, or when the wood closes in and
pinches the saw chain in the cut
(cf. fig. b).
• Tip contact in some cases may cause
a sudden reverse reaction, kicking the
guide bar up and back towards the
operator (cf. fig. a).
• Pinching the saw chain along the top
of the guide bar may push the guide
bar rapidly back towards the operator.
• Either of these reactions may cause
you to lose control of the saw which
could result in serious personal injury.
Do not rely exclusively on the safety
devices built into the electric pole-
mounted pruner. As a user of the elec-
tric pole-mounted pruner, you should
undertake various measures to enable
accident-free and injury-free working.

Further safety directions

• The equipment is not intended for use
by people of restricted physical, sen-
sory or mental ability.
Children must not play with the de-
vice.
• Damaged cables, coupling and plugs
or connecting leads, not correspond-
ing to the specifications, must be not
be employed. Remove the plug im-
mediately from the plug socket in case
of damage or cutting through of the
mains cable.
b
• Basically the mains cable is dragged
behind the operator. The cable must
always lead away from the electric
pruner towards the rear.
• Check that the cutting equipment
stops rotating when the engine is
idling.
• National regulations may limit the use
of the pruner.
• A daily inspection of the device is
necessary before use, or if it has been
dropped or impacted in any other way,
in order to determine any significant
damage or defects.
• Danger! Never use the machine in the
vicinity of overhead power lines.
• Wear non-slip shoes and close-fitting
clothing.
• Warning! Never use the machine if
you are tired, ill or under the influence
of alcohol or other drugs.
• Warning! Warning of the danger to
third parties and the need to keep
them at a safe distance from the ma-
chine during work.
• Remove branches in sections. Warn-
ing! Take care to work in a safe
position so as not to be hit by falling
branches or by branches that bounce
back when they fall to the ground.
• Exhaust emissions warning.
• When using the machine, take a
break and change working positions

Assembly

Always wear protective gloves
when working with the saw
chain and use only original
parts. Disconnect from the
mains before working on the
chainsaw. There is a risk of in-
jury!
GB
91