Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Cleaning
Do not use solvents or petrol for
cleaning. These could damage the
equipment.
•
Clean the surface, ventilation open-
ings and handles of the equipment
with a dry cloth, brush or hand brush.
•
Only dry wipe the saw chain. After
cleaning, lightly oil the saw chain with
chain oil.
Apply individual drops of oil to the
joints and the points of the teeth on
the individual chain links.
Sharpening the cutting teeth
Leave the resharpening of a saw chain to
a specialist or proceed according to the
instructions for your saw chain sharpener.
Resharpening a saw chain takes practice.
If in doubt, it is preferable to replace the
saw chain.
Changing the saw chain
Never fix a new saw chain on a
worn set of teeth or on a damaged
or worn blade.
1. Switch off the equipment and discon-
nect from the mains.
2. Undo the blade fixing screw (
and take off the chain wheel cover (
6)
3. Take off the old saw chain (
The assembly and tensioning of the new
saw chain are described in the "Assem-
bly" chapter.
96
1. Switch off the saw and pull out the
power plug (
2. Remove the sprocket chain wheel
covering (6), the saw chain (2) and
the chain bar (3).
3. Check the chain bar (3) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passages (
the chain bar, in order to guarantee
a trouble-free, automatic oiling of the
saw chain during operation.
5. Mount chain bar (3), chainsaw (2) and
sprocket chain wheel covering (6) and
tighten the chainsaw.
The chain bar (3) must be turned round
every 10 working hours, in order to guar-
antee uniform wear.
Turning over the bar (3) requires you to
move the tensioning screw (
5)
other side of the bar. Unscrew the retain-
ing bolt (
tensioning screw. Move the tensioning
2).
screw over to the other side of the bar and
screw the retaining bolt back (
Maintaining the blade
Use cut-protection gloves when
handling the chain or the chain
bar.
31).
A
When the oil channels are in opti-
mum condition, the saw chain au-
tomatically sprays a little oil a few
seconds after the saw is started.
30b) attaching the bar to the
N
27) of
B
30a) to the
N
30b) in.
N
Publicidad
Capítulos
Tabla de contenido
