BAUKER MP170 Manual De Instrucciones página 44

1. Always make sure the rotary tool is "OFF" and
disconnect the plug from the power source or the
battery pack from the tool before changing
accessories.
2. Press the Shaft lock button (4), unscrew and remove
the collet nut or chuck (2) using the collect wrench (9).
3. Select the proper mandrel to attach in the collar.
Most of the accessories are sized 3.2 mm.
4. Slide the sanding band down until the entire mandrel
is covered.
5. Place two fingers underneath the mandrel and pull
firmly up. This will place the drum in the "unlocked"
position. To return to "locked" position, press firmly
down on the top of the mandrel
6. Place the mandrel into collet as deep as possible and
tighten collet nut.
85
Replacing accessories
Loading cutting and sanding tool
1. Place the mandrel into collet as deep as possible and
tighten collet nut using the 2 in 1 collet wrench (9).
2. Remove the bolt using the 2 in 1 wrench (9) and
insert the bolt through the collar.
3. Tighten the bolt and attach the mandrel.
Instructions for the use
Special Safety Ruler
of Mini Grinder
for rotary tools
86