Panel Description - Ebode HDBT600 Guia Del Usuario

6.2 ebode HDBT602 - including Bi-directional IR & RS-232
7.

PANEL DESCRIPTION

7.1 Link LED
The LED indicator will flash once CAT6 cable has been properly connected between the
transmitter and receiver. Once both devices are connected and powered, the LED stops
flashing and stays on to indicate successful connection between transmitter and receiver.
7.2 Power LED
The LED indicator will activate once the included 5V DC power adapter has been properly
connected between the transmitter and receiver unit and a power socket. Note: the LED
will blink during the initial power up time during which it is loading the device firmware.
7.3 HDMI IN
Connect one HDMI cable between this port and the HDMI output port of the source
device (DVD, Set-top box, blue-ray DVD)
7.4 HDMI Out
Connect one HDMI cable between this port and HDMI input port of display device
7.5 IR Receiver
Connect the IR receiver cable to this port. Output device can be controlled from the
location of the transmitter or receiver unit by way of its original IR remote control or a
universal type IR remote control.
7.6 IR Blaster
Connect the IR emitter cable to this IR port and place the connected IR emitter module
on the IR Extender zone of devices.
7.7 DC 5V
Connect the 5V DC power supply to this port.
7.8 RJ45
Connect one 100 Ohm CAT5e/6 cable between this port of transmitter and receiver unit.
6-10-2015 5 ebode HDBT600/HDBT602