Safety Instructions; Important Safeguards - Krups KH7004 Manual De Instrucciones

IFU_KR_TOASTER_PRECISION_NC00014289.qxd:Mise en page 1

SAFETY INSTRUCTIONS

IMPORTANT SAFEGUARDS:

I
This appliance is not intended to be operated using an external timer or
separate remote control system.
I
For your safety, this appliance conforms with applicable standards and
regulations (Directives on low voltage, electromagnetic compatibility, ma-
terials in contact with foodstuffs, environment, etc.)
I
In accordance with the CSC notice of 2/12/04, this product features a
mechanical design allowing the bread ejection mechanism to be detached
from the power cut-off element.
I
Check that the electricity supply voltage corresponds to the voltage
indicated on the appliance (ac current only).
I
Given the many standards in effect, if this toaster is used in a country other
than the country where it was purchased, have it checked by an approved
service centre (see enclosed after sales service information).
I
Check that the electricity installation is sufficient to supply the power
required by this appliance.
I
Always plug the toaster into an earthed socket.
I
Use extension leads which are in good condition, with an earthed connection,
and with a minimum rating of 10A.
I
This appliance is intended to be for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufactu-
rer accepts no responsibility and the guarantee will not apply.
It is not intended to be used in following applications, and the guarantee will
not apply for:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
TO PREVENT ANY ACCIDENTS
When using electrical appliances, basic safety precautions should always
be followed:
DO
I
Carefully read and follow all the instructions for use.
I
The toaster must always be used in the upright position, never on its side
or tilted forwards or backwards.
I
Before each use make sure that the crumb tray is fitted correctly.
I
Regularly remove crumbs from the crumb tray.
I
The bread control lever must be in the "Up" position before plugging in or
unplugging the appliance.
I
Unplug the appliance if it shows any working abnormalities.
22/04/10 14:41
English
15