OHAUS a-AB23EC Manual De Instrucciones página 7

a-AB23EC Bench Conductivity Meter
Button
Exit
Store
Recall
Mode
TDS-F
Read/Enter
Auto - Stop
Standard
Temp
Cal
Cal.Data
Press & release

Turns on the meter

Cancels the current
measurement

Exits calibration

Stores the current
measurement result

When checking the stored
measurement results, moves
to the previous record.

When setting parameters,
increases the setting value or
displays the previous option.
Switches between EC, TDS and
SAL mode.

Starts or ends measurement

Ends the current
measurement in the auto
endpoint mode and shows the
result

Confirms settings and stores
setting parameters

Selects standard solution

When checking the stored
measurement results, moves
to the next record.

When setting parameters,
decreases the setting value or
displays the next option.
Starts calibration
Press & hold
for 3 seconds
Turns off the meter
Recalls stored measurement
results
Sets TDS-F value
(Ranging from 0.4 to 1.00, and
the default is 0.5.)
Switches between auto and
continuous endpoint mode
Auto
Continuous
Enters temperature setting:
1. Selects temperature unit.
2. Sets MTC temperature.
(The defaut is 25°C.)
3. Sets reference
temperature.
4. Sets temperature
correction coefficient
value. (Ranging from 0 to
10, and the default is
2%/degree)
Recalls the latest calibration
data
EN-5