Philips 9000 Serie Manual Del Usuario página 10

English
10
3 Start trimming where you want to define the edges of your beard
and use the laser guide to guide you during trimming.
Tip: Hold the appliance so that the laser light shines exactly on the edge you
want to trim and then place the trimming head on your skin.
4 When you are finished, press the on/off button to switch off the
appliance.
Tip: When the motor of the appliance is not operating, the laser guide switches
off automatically within 3 minutes. In the 3 minutes before the automatic
switch-off of the laser guide, you can use the laser guide to check if the
contours of your beard are symmetrical or straight.
5 Push down the top of the laser guide to lock it in 'off' position
('click').
Trimming without comb
If you trim without comb, your hair is cut off close to the skin. The trimming
head has a 32mm (1.25in) side and a 15mm (0.6in) side. The 15mm (0.6in)
side of the trimming head allows more precise styling and contouring than
the 32mm (1.25in) side.
1 If one of the combs is still on the trimming head, pull it off.
Never pull at the flexible top of the comb. Always pull at the sides.
2 Turn the trimming head until the side you want to use points to the
front of the appliance.