Tripp-Lite DWM3770PLX Manual Del Propietário página 5

1b. Mount on Solid Brick or Concrete Block
• When installing wall mounts onto a concrete masonry unit (also known as a CMU
or "cinder block"), verify that the actual concrete thickness is at least 35 mm
(1-3/8 inch) in order to hold the two concrete anchors. DO NOT DRILL INTO MORTAR
JOINTS! Be sure to mount the wall-mount plate with the included concrete anchors
and anchor bolts onto a solid section of the block. The solid sections can generally
be found 25 mm (1 inch) toward the middle of the block from either end. An electric
drill on a slow setting is suggested to drill the hole rather than a hammer drill so as
to avoid breaking out the back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
16-05-005-9335EC.indb 5
Anchor Bolt
Concrete Anchor
WARNING
60 mm
(2.4")
5
10 mm
3/8")
1
Find and mark the exact
location of mounting holes
2
Drill pilot holes
Screw the wall
mount onto
the wall
5/23/2016 4:43:29 PM