V2 DEV-R1 Manual Del Usuario página 9

DUO SERIES TRANSMITTERS STORAGE
PROCEDURE
To store a transmitter TX1 on a blank control unit proceed as
follows:
WARNING: the first transmitter stored fixes the direction of
motion of the motor
1. Set switch 1 on the transmitter to ON.
NOTE: All the other switches must be set to OFF.
2. DUO4/6/12 only: press several times the key SELC of the TX1
transmitter until the leds display the channel to be stored
3. Press the button SW1 of the module DEV-R1 to be
programmed: the led L1 lights up
4. Press and hold (for about 5 seconds) the PROG button of the
TX1 remote control until the motor starts to move in a
direction: the led L1 turns off
5. Release the key PROG: the motor stops.
6. Press the keys UP or DOWN depending on the way of motion
of the roll-up shutter before stopping:
- if the roll-up shutter was going up, press the key UP;
direction acquired: the key UP moves the roll-up shutter
UPWARDS, the key DOWN moves the roll-up shutter
DOWNWARDS.
- if the roll-up shutter was going down, press the key DOWN;
direction acquired: the key DOWN moves the roll-up shutter
DOWNWARDS, the key UP moves the roll-up shutter
UPWARDS.
7. Set the switch 1 to OFF.
Try to operate the roll-up shutter and check that it works with
the logic above described. If the logic is reversed, it is necessary
to delete all the codes stored and start again the above
procedure.
To add another transmitter TX2 to the control unit it is necessary
to use a remote control previously stored (TX1) and proceed as
follows:
1. DUO4/6/12 only: press several times the key SELC of the
transmitter TX1 until displayed the channel stored (by the
leds)
2. DUO4/6/12 only: press several times the key SELC of the
new transmitter TX2 until display the channel to be stored
(by the leds)
3. Take the roll-up shutter to half its way with TX1.
4. Set to ON the switch 1 of the transmitter TX1.
5. Press and keep pressed for about 5 seconds the key PROG of
the TX1 until the motor starts to move.
6. Release the key PROG, the motor stops.
7. Press the key UP or DOWN of the TX2: the transmitter is
stored with the same logic of the TX1.
CLEARING THE MEMORY WITH DUO SERIES
TRANSMITTERS
If you own one of the transmitters stored in memory, proceed as
follows:
1. DUO4/6/12 only: press several times the button SELC on
the transmitter until displayed the channel stored (by the leds)
2. Position the roll-up shutter at the mid-height
3. Set on ON the switch 3 of the transmitter
4. Press and keep pressed the button PROG of the transmitter
until the motor moves in both the ways for 1 second,
showing the end of deletion.
5. Release the button PROG and set on OFF the switch 3 of the
transmitter.
If you do not own one of the transmitters stored in memory,
proceed as follows:
1. Move the rolling shutter to half-height
2. Set switch 3 of a transmitter to ON.
3. Press the button SW1 of the module DEV-R1: the led L1
lights up
4. Press and hold the PROG button of the transmitter until the
motor moves for approx. half a second in both directions,
indicating the end of the clearing: the led L1 turns off
5. Release the PROG button and set switch 3 of the transmitter
to OFF
9