Declaration Of Conformity; Starting Operation - Bosch Professional GAS 25 Manual Original

OBJ_BUCH-464-003.book Page 14 Thursday, February 19, 2009 12:48 PM
14 | English

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60335 accord-
ing to the provisions of the directives
2006/95/EC, 2004/108/EC.
01
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
19.01.2009
Assembly
Before any work on the vacuum cleaner it-
self, pull the mains plug.
Replacing/Inserting the Dust Bag
(see figure A)
– Unlock the latches 10 and remove the vacu-
um lid 3.
– Pull off the full dust bag 11 from the connec-
tion flange toward the rear. Close the open-
ing of the dust bag by folding down the lid.
Remove the closed dust bag from the vacu-
um cleaner.
– Slide the new dust bag 11 over the connec-
tion flange of the vacuum cleaner. Make sure
that the full length of the dust bag 11 faces
against the inner wall of the container 9.
Reattach the vacuum lid 3.
– Lock the latches 10.
For dry vacuuming operation, a dust bag 11
should be inserted. When operating with a dust
bag 11, the folded filter 12 clogs slower, the vac-
uuming performance is kept up longer and the
disposal of dust becomes easier.
1 609 929 S23 | (19.2.09)
Mounting the Vacuum Hose
(see figure A)
Mount the vacuum hose 8 onto the hose connec-
tion piece 7 and turn it in clockwise direction to
the stop.
Insert the extension tubes firmly into each oth-
er.
Note: Bosch recommends using static-discharg-
ing hoses with a hose Ø of 19 or 35 mm.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
vacuum cleaner. Equipment marked with
230 V can also be operated with 220 V.
Switch the vacuum cleaner off immediately
as soon as foam or water comes out, and
empty the container. Otherwise, the vacuum
cleaner can become damaged.
Symbols on the Mode Selector Switch
on Switching On
off Switching Off
Electromagnetic filter cleaning
Operation with remote automatic
switching
Switching On and Off
To start the operation of the vac, set the mode
selector switch 4 to on.
To switch off the vac, set the mode selector
switch 4 to off.
Bosch Power Tools