Tripp-Lite SUPDMB20K El Manual Del Propietario página 4

Mounting
Note: It is recommended that the following mounting
instructions only be used in standard rack enclosures and
4-Post Open Frame Racks.
1
It is important to note that in order to accommodate paralleling
applications, equipment must be mounted in the following
order (see diagram): UPS Power Module 1, UPS Power Module
2, Battery Module 1 and Battery Module 2. Note: The power
module and battery module must be installed in separate
shelves.
2
The included plastic pegs
empty rackmount shelves
mounting hardware. Insert a peg near the center of the front
and rear bracket of each shelf as shown. (Each front bracket
has 6 holes and each rear bracket has 3 holes.) The pegs will
snap into place.
After installing the pegs, expand each shelf to match the depth
of your rack rails. The pegs will fit through the square holes
in the rack rails to support the shelves. Refer to the rack unit
labels to confirm that the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
3 B
Secure the shelves to the mounting rails permanently using
the included screws and cup washers
• For 2U equipment mounting, place 4 screws total at the
front and 4 screws total at the back.
• For 3U equipment mounting, place 6 screws total at the
front and 4 screws total at the back.
Tighten all screws before proceeding.
Warning: Do not attempt to install your equipment until
you have inserted and tightened the required screws.
The plastic pegs will not support the weight of your
equipment.
4 D
Attach mounting ears
E
equipment using the screws provided
face forward.
5
Using an assistant, lift your equipment and slide it onto the
mounting shelves. Attach your equipment to the rack by
passing the screws, nuts and washers (user-provided)
through its mounting ears and into the rack rails.
A
will temporarily support the
B
while you install the permanent
C
as shown.
to the front mounting holes of your
F
. The ears should
G
1
A
1
B
C
2
C
3
E
4
G
5
4
UPS Power Module 1
UPS Power Module 2
Battery Module 1
Battery Module 2
B
A
C
C
B
F
D