Hayward AquaRite LT Manual Del Usuario página 21

Ocultar thumbs Ver también para AquaRite LT:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
The AquaRite LT is a pool treatment system.
It can be used to treat your pool effectively by salt water electrolysis. For the chlorinator to function, it requires a low concentration of
salt (sodium chloride) in the pool water. The Aqua Rite LT automatically disinfects your pool by converting the salt into free chlorine
which kills the bacteria and algae in the pool. The chlorine reverts back to sodium chloride. This continuous cycle means that there is
no need to treat your pool manually.
The AquaRite LT is suitable for treating most residential swimming pools.
The quantity of chlorine required to treat a swimming pool correctly varies according to the number of bathers, the rainfall, water
temperature and the cleanliness of the pool...
NOTE: Before installing this product on the filtration system of a pool or spa with an adjacent natural stone terrace or deck, consult a
qualified installer who will advise you on the type, installation, sealant (if any) and maintenance of stone that can be laid around a saline
pool.
NOTE: The use of dry acid such as sodium bisulfate to adjust the pH of the swimming pool is not recommended, especially in arid
regions where pool water is subject to significant evaporation and is not commonly diluted with mains water. Dry acid can cause a build-
up of by-products that can damage your chlorinator.
Description
220 mm
Page 4 of 16
INSTALLATION
300 mm
135 mm
ELECTRONIC BOX
Main connection 230 V - 50 Hz
A
Cell connection
B
Gas detector connection
C
4 A Fuse
D
4 A Fuse
E
pH and Rx connection
F
ON/OFF switch
G
USE ONLY GENUINE REPLACEMENT PARTS
GENERAL
AquaRite LT
Øint
63 mm
120 mm
Øext 63
mm
130 mm
CELL
Electrolysis cell
A
Connection to unit
B
Cell housing
C
Flow/gas detector (internal)
D
170 mm
Rev. A

Publicidad

Tabla de contenido
loading

Tabla de contenido