Tabla De Contenido; Installation Hardware; Preparation Of The Oven - Electrolux EI30MH55GS Instrucciones De Instalación

6 InstallatIon HardWarE

The INSTALLATION HARDWARE items 1 - 7 are in a small
bag. Items 8 - " are packed separately. All items are in a small
carton packed below the oven.
Item
Wood Screw 5 x 30 mm
1
with nuts #10 - 24 x 50 mm
Toggle Bolt
2
Top Cabinet Screw 5 x 60 mm
3
Top Cabinet Screw 5 x 60 mm
4
Tapping Screw 4 x 12 mm
5
Flat Washer 30 mm diameter
6
Grommet
7
Rear Cushion
8
Exhaust Damper Assembly
9
Scale Plate Spacer
!
Grease Filter
"
* Must use two - may use remaining four.
** May not use all - depending on stud location.
Parts shown not to common scale.
Installation Instructions
name quantity
Figure 4

7 PrEParatIon of tHE oVEn

1. Turn oven on the side. See Figure 5.
2. Follow steps (A)-(D) to remove mounting plate from the back
of the oven as shown in Figure 5.
(A) Release mounting plate by pulling out the lever that is on
the bottom of the oven. See Figure 6.
6*
(B) When lever is out, pull that side of the mounting plate away
4** from the oven. See Figure 5.
(C) Repeat step (A) on other side.
1
(D) Repeat step (B) on other side.
1
8
2
1
1
1
2
2
Use screwdriver to
assist in releasing
mounting plate.
3
(A)
(C)
Figure 5
(A)
Bottom of
Microwave
Figure 6
(B)
(D)
Mounting
Plate
E