GE WX9X2 Instrucciones De Instalación página 13

5
Remove and swap the 2 cover caps and door handle
from the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B. Squeeze the tabs on the inside of the cover caps.
Push caps through the outer door.
Inside of door
Cover caps
C. Push the door handle clips into the openings on the
opposite side of the outer door making sure you
flip the handle so it curves to the inside.
D. Push the cover caps into the openings on the outer
door where the handle was removed.
Inside of door
Door handle clip
Installation Instructions
Door
handle
clip
Door handle
Cover cap
Door handle
6
With the cover caps and door handle in place, mount
the inner door back into the outer door with the
screws removed in step 4. Make sure you mount the
hinges on the side opposite the handle.
Inside screws
Edge
screws
7
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge
screws loosened in step 3 into the lower left side
screw holes and firmly tighten all 4 screws.
Door
8
Install the 4 plastic caps removed in step 1 into the 4
right side front panel holes.
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
When you finish
Plug the dryer back into
its electrical outlet.
13
Door
hinge
screws
Inside screws
Handle
Hang door and
tighten screws