Installation Instruction; Before Installation; Step 1-Selecting An Installation Location & Installing The Roof Top Air Conditioner - Quipon GRH085DA-K3NA2B Manual De Usuario

BEFORE INSTALLATION

Testrun the unit with proper power supply. Refer to the operation instruction section in
the Owner's Manual Operation & Installation. Make sure all the controls operate
correctly then disconnect the power supply of the unit.
▪ Before installation, please check whether the unit is assembled with three pieces of
rubber pads and square sealing strip.
! WARNING
Moving parts may cause personal injury. Be careful when test the unit. Do not operate the unit with exterior cover removed.
STEP 1-SELECTING AN INSTALLATION LOCATION & INSTALLING THE ROOF TOP AIR
CONDITIONER
Your air conditioner has been designed for use in recreational vehicles.
Check the roof of the vehicle to determine if it can support both the roof top unit and the ceiling assembly without
additional support. Make sure the interior ceiling mounting area will not interfere with existing structures.
Once the location for your air conditioner has been determined. A reinforced and framed roof hole opening must be cut
(if there is no hole) or you may use existing vent holes.
CASE A.
If a roof vent is already present in the desired mounting location for the air conditioner, the following steps must be
performed:
1.
Remove all screws which secure the roof vent to the vehicle. Remove the vent and any additional trim. Carefully remove
all chalking from around the opening so the surface is clear.
2.
It may be necessary to seal some of the old roof vent mounting screw holes which may fall outside of the air conditioner
basepan gasket.
3.
Examine the roof opening size, if the opening is small than 356x356mm, the opening must be enlarged. If the opening
exceeds 356x356mm, a mounting plate (frame) must be fabricated to reduce the opening size (See Figure 1).

INSTALLATION INSTRUCTION

- 47 -