Remote Control - Dimplex DCF44GS Manual Del Propietário

Operation
Temperature Cutoff
Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting five (5) minutes and
plugging the unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dimplex
north america Limited at 1-888-
346-7539. Please have your
model and serial number ready
when calling.

Remote Control

The remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with 243
independent frequencies to
prevent interference with other
units.
Battery Installation
1. Depress tab on the battery
cover on the back of the
remote control and remove
battery cover (Figure 2).
2. Install two (2) aaa batteries
into the remote control
(included).
3. Ensure child lock is in the
"unlocked" position.
4. Replace the battery cover.
!
NOTE: When the "BaT"
symbol is present on the remote
control it is recommended to
replace the batteries promptly,
to maintain full functionality of
the remote/fireplace. The remote
control has a battery backup time
of only several hours.
Battery must be recycled
or disposed of properly.
Check with your Local
authority or Retailer for recycling
advice in your area.
Figure 2
Batteries
Child Lock
9