Sebson BWM ALARM B Instrucciones De Manejo página 8

Inserting or changing the batterie (Fig.2):

Open the battery compartment on the back.

Insert 1 battery type: E 9V into the battery compartment. Note: Make sure that the polarity is correct when
inserting the batteries!

Close the battery compartment again after inserting the battery. Make sure that the battery compartment is
always closed! Do not use the device if the cover of the battery compartment is damaged or missing!
 Note the general information about using batteries (see "General instructions for using batteries").
General instructions for using batteries:
Danger:
Never expose batteries to extreme conditions, such as heat or strong sunlight! There is an acute risk of
explosion and leakage!
Danger:
Make sure that batteries can not be swallowed by children, animals and adults! In particular, keep children
and animals away from this product! If one or more batteries are swallowed, seek medical attention immediately!
Here is an acute danger to life. The substances contained in the battery can cause severe poisoning!
Caution:
Remove leaking batteries from the device immediately! The battery acid contained in the battery can
damage the unit! Avoid direct skin contact with leaking batteries! Wash your hands immediately after contact and
take care that the battery acid does not get into your skin, eyes or mucous membranes! Dispose of leaking and old
batteries according to the regulations.

Replace old batteries with batteries of the same type!

Do not use rechargeable batteries. They have a too low voltage!

Remove the batteries from the battery compartment when you are not using the remote control for more than
a month. Make sure that the battery compartment is always closed when the battery is inserted!

Only operate the device when the battery compartment is closed!

Non-rechargeable batteries are not to be re-charged!

New batteries should not be used together with used batteries!

Always use batteries with the same type!

Never short the terminals of the batteries!
Start up and mounting:
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!
Note:
Observe the safety instructions and technical data before installing this product!
Functions of the switch (see Fig.5):
CHIME: Socket ready for operation, Sensor deactivated
OFF: Switched off
ALARM: When motion is detected, a continuous alarm tone sounds for 15 seconds. Note: Leave the detection area
within 30 seconds after activation.
To ensure optimum sensitivity of the sensor, install the device in the room in such a way that the movements are
transversely to the device. Movements that are directly to and from the device are less well detected:
Do not operate the device in the immediate vicinity of:

Metal surfaces e.g. metal door frames

electronic devices such as computers, monitors etc

Heat sources e.g. radiant heaters, radiators or lamps

fume cupboards or fans

luminaires (minimum distance from luminaires >50cm)
8