Before Use - Hilti DC-EX 125/5"M Manual De Instrucciones Original

4.2 Diamond cutting discs
Application
Designation
Material
5

Before use

5.1 Fitting the hood
1. Fit the guard on to the arbor collar so that the two triangular marks on the guard and on the power tool
are in alignment.
2. To bring the hood to the desired working position, pivot the device radially while pressing the catch on
the angle grinder.
◁ The catch engages with an audible click.
5.2 Opening hood
1. Press the catch.
2. Open the front clip.
3. Press the locking catch.
4. Open the hood.
5.3 Fitting the diamond cutting disc for slitting applications
The use of Kwick-Lock nuts for this application is not permitted.
For this application you need the slitting adapter set, which is additionally available.
1. Remove the clamping flange for the arbor.
2. Screw the adapter on to the arbor and tighten it securely.
3. Insert a diamond cutting disc, observing the specified direction of rotation.
4. Fit the spacer rings for the desired width between slits.
5. Insert a diamond cutting disc, observing the specified direction of rotation.
6. Screw on the clamping nut and tighten it securely with the pin wrench.
7. Close the hood.
5.4 Fitting a diamond cutting disc
1. Fit the clamping flange on to the arbor.
2. Place the first diamond cutting disc on the clamping flange.
Observe the specified direction of rotation.
3. Screw on the Kwick-Lock nut until it is seated against the cutting disc.
4. Close the hood.
5.5 Setting depth
1. Release the locking screw.
2. Push the back panel to the desired position.
◁ The scale shows the group.
3. Firmly tighten the locking screw.
5.6 Plunge function
1. Position the carriage plate on the work.
2. Switch on the tool.
267722
*267722*
Printed: 08.06.2018 | Doc-Nr: PUB / 5128904 / 000 / 02
3
4
5
Diamond cutting disc
Cutting, slitting
DC­D
Mineral
8
English 9