Technical Data; Before Use; Fitting The Side Handle - Hilti AG 500-12D Manual De Instrucciones

Item Equipment
D DC-EX 125/5"C dust
hood for cutting (only
in conjunction with A)
E Side handle
F DCBG 125 hoop
handle (optional for
E)
G Clamping nut (not for
use with accessories
with integrated
thread)
H Clamping flange
(not for use with
accessories with
integrated thread)
I Kwik lock (optional
for G)
J Clamping nut for
abrasive resin-fiber
disc
K Support plate
L Guard type 27

5 Technical data

When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
The information given applies to a rated voltage of 120 V. The data may vary in the event of deviations from
the rated voltage and for country-specific versions. Please refer to the power tool's rating plate for details of
its voltage, frequency, current and input power ratings.
Rated current input
Rated frequency
Maximum disc diameter
Weight
Drive spindle thread

6 Before use

CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and
when troubleshooting.

6.1 Fitting the side handle

▶ Screw the side handle into one of the threaded bushings provided.
8 English
AC­D AG­D, DG-CW
AF­D, (SPX,
AN­D SP, P)
— — —
X X X
X X X
X X X
X X X
X X —
— — —
— — —
— — —
AG 500-12D
12.5 A
60 Hz
5 in
5.7 lb
(2.6 kg)
5/8"-11
DC-TP, AP-D 3CS,
DC-D 4CS,
(SPX, 3SS,
SP, P) 4SS
X —
X X
X X
X —
X —
X —
— X
— X
— —
AG-D
type 27
— —
X —
X —
— —
— —
— —
— —
— —
— X