Connecting The T4S Via Digital Connection - Bose T4S ToneMatch Guia Del Propietario

System Setup

Connecting the T4S via Digital Connection

1. Make sure the L1 Model 1S/II and T4S are powered off and the T4S Master volume control is set to
minimum.
2. Plug one end of the ToneMatch® cable into the Power port/Digital Main Output R on the T4S. Plug the
other end of the ToneMatch cable into the ToneMatch port on the power stand.
Note: To connect the T4S to two L1 Model 1S/II power stands, connect a second power stand to the Digital
Main Output L port on the T4S using a ToneMatch cable.
3. Turn on the mixer and then turn on the L1 Model 1S/II power stand.
4. Connect your instruments and adjust levels. Refer to "Optimizing Input Gain and Output Volume" on
page 17.
Figure 9. Two L1 model II systems connected to a T4S via digital connection
Note: The T8S cannot be connected digitally and cannot be powered by the L1 Model 1S/II.
12 - English
MONO
USB AUDIO
M