Connecting The T4S/T8S To Your Computer; Connecting A Flash Drive To The T4S/T8S - Bose T4S ToneMatch Guia Del Propietario

Connecting the T4S/T8S to Your Computer

The T4S/T8S provides a USB port for connecting it to a computer. This allows you to download performance
scenes to a computer or install system updates. Visit www.Bose.com/livesound for details on updating your
system.
When connected to a computer, you also can use the T4S/T8S as a general-purpose USB audio device for
recording/playback.
Note: The T4S/T8S operates at
need to configure the software settings for 48 kHz/24-bit
Note: Connecting the T4S/T8S to your computer requires a USB cable (Type A to Type B, not supplied).
1. Connect the mixer to a power source (ToneMatch® power supply for T4S/T8S or an L1 Model 1S/II for T4S only).
2. Plug one end of the USB cable into the mixer's USB 2.0 Type-B port (Figure 12).
3. Plug the other end of the USB cable into a USB port on your computer.
4. Turn on the mixer.
Figure 12. T4S-to-USB connection
To computer
USB port

Connecting a Flash Drive to the T4S/T8S

Plug in a USB 2.0/3.0 flash drive loaded with WAV/MP3 files into the USB 2.0 Type-A port to playback audio
tracks to your mixer.
Figure 13. Connecting a flash drive to the T4S
48 kHz/24-bit. When using the T4S/T8S with recording software, you may
Power switch
USB cable
(Type A to Type B)
operation.
ToneMatch port – To an L1 Model 1S/II
system or an ToneMatch power supply
System Setup
English - 15