Troubleshooting - Hamilton Beach 67951 Manual De Instrucciones

Troubleshooting

PROBLEM
Motor appears to stall
when juicing.
Excess pulp building up
in the micro-mesh
strainer.
Pulp is too wet and
insufficient juice is
produced.
Juice sprays out of spout.
Juice drips out of spout
immediately after juicing.
Food won't move in food
chute.
Juicer will not work.
PROBABLE CAUSE/SOLUTION
• The juicing action may be too vigorous. Try slower juicing action by pushing the food pusher down more
slowly. Refer to page 6, Step 3 or press REVERSE button to dislodge food.
• Juicer never taken apart and cleaned.
• Too much food juiced before cleaning with brush.
• Unplug. Remove strainer and clean mesh walls with a fine brush. This will remove excess fiber buildup
which could be inhibiting the juice flow.
• Try a slower juicing action.
• Unplug. Remove strainer and clean mesh walls with a fine brush. This will remove excess fiber buildup
which could be inhibiting the juice flow.
• Try a slower juicing action by pushing the food pusher down more slowly. Refer to page 6, Step 3.
• With motor ON, raise and lower food pusher in feed chute several times. The action forces remaining pulp
and juice out of the strainer.
• Food is stuck in the juicer chute. Press REVERSE button to allow food to move in juicer chute.
• Juicer has been operating for 30 minutes or more. Press ON button to reset and begin juicing.
13