Uline H-8462 Guia De Inicio Rapido página 2

1. Attach two large casters to back of base. Secure
each caster with four M8 x 20 mm bolts and four
M8 washers. Tighten with 1/2" socket. (See Figure 1)
Large Casters
Bottom
View
Figure 1
2. Flip base upright. Attach small casters to front
of base. Secure with four M8 x 20 mm Phillips
countersunk screws, four M8 washers and four M8
hex locknuts. Tighten with 1/2" socket. (See Figure 2)
Top
View
Small Casters
Figure 2
3. Attach upright
to base. Secure
both sides with
M16 x 100 mm bolt,
M16 washer and M16
hex locknut. Tighten
with 15/16" socket.
(See Figure 3)
PAGE 2 OF 12
ASSEMBLY
Figure 3
Upright
4. Attach handle and support braces on each side
of upright. Secure all parts with M16 x 120 mm bolt,
M16 washer and M16 hex nut. Tighten with 15/16"
socket. (See Figure 4)
NOTE: Hand tightening may be needed for steps
4 and 5 to allow bolts to align. Once steps 4 and
5 are complete, fully tighten with 15/16" socket.
Figure 4
Support Brace
5. Attach support braces to inside of both sides of
base. Secure each side with M16 x 100 mm bolt,
M16 washer and M16 hex locknut. Tighten with 15/16"
socket. (See Figure 5)
Figure 5
6. Attach two large casters to legs. Secure each caster
with four M8 x 20 mm bolts and four M8 washers.
Tighten with 1/2" socket. (See Figure 6)
Figure 6
Handle
Support Brace
0821 IH-8462