Important - Echo 99944100001 Instrucciones De Instalación

NOTE
Be sure cable, lead and hose are properly seated in clamp and
not pinched during assembly.
15. Secure ignition ground lead (O) with socket head bolt to
lower left engine crankcase.
16. Connect ignition coil lead and stop switch lead at coupler
(K). Remove lower right crankcase bolt (P), assemble wire
clamp onto bolt and reassemble bolt.
17. Bend clamp over coil leads.
18. 99944100001
Remove screw (Q) from lower tube clamp and loosen grip
adjustment knob (R) and slide tube clamp over swivel pipe.
Position throttle handle assembly for comfortable operation.
Tighten lower clamp screw (Q) securely.
19. 99944100002
Loosen knob (R) on handle (S). Align notch in handle with
tabs (T). Install onto swivel pipe (U) past long ridges in pipe.
Move handle (S) to desired position. Tighten knob (R) hand
tight.
20. Check for smooth throttle operation.
21. Secure throttle cable and ignition wire tube assembly with
plastic cable ties (T).
22. Install engine cover and secure with four (4) crosshead
screws.
23. Connect spark plug boot to spark plug.
24. Check that engine will stop when ignition switch is moved to
"STOP" position. (Do not operate blower without a properly
functioning engine stop switch.)

IMPORTANT

Always reinstall spark plug cover on LN models, otherwise
engine cooling is greatly reduced, and will cause engine
failure.
O
3
P
K
R
T
Q
R
T
U
S
T