Powering The Hub - Tripp-Lite U460-2A2C-IND El Manual Del Propietario

Powering the Hub

DC-In
To power the hub, connect the included power adapter to the unit and then to
a wall outlet.
Power Terminal
A 2-wire terminal block is installed onto the unit to power the hub using a
power terminal.
Operation
1. Using the included USB Type-C cable, connect the USB-C port labeled
Host to your laptop, computer or any USB-C device.
2. Using the included terminal block or power adapter, power the unit via the
desired powering method. A blue LED will illuminate to indicate the unit is
receiving power from the power source.
3. Connect up to two USB devices to the USB-A hub ports.
4. Connect up to two USB devices to the USB-C hub ports.
5. LEDs will illuminate and blink green as each device is connected to
indicate it is connected to the hub.
Note: If USB ports are not properly working, unplug all devices as well as the
power source. After 10 seconds, repeat installation steps.
18-10-442-9338BF.indb 5
5
12/12/2018 11:39:40 AM