Product Specifications - Matrix C7 Serie Manual Del Usuario

MAINTENANCE SCHEDULE
ACTION
Unplug the unit. Clean entire machine using water and a mild soap or other Matrix approved solution (cleaning agents should be alcohol and ammonia free).
C3x / C3xe: Unplug the ClimbMill and remove the access panel. Clean chain of old grease and re-apply a lithium-based grease to each chain link.
Check step motion and stability to ensure the ClimbMill does not rock or wobble.
Check all connecting joint areas for tightness of bolt assemblies.
Ensure that there is little, or no free play at all joint assemblies once bolts have been tightened. Installation of washer kits may be required if free play does not
come out from tightening bolts.
Unplug the ClimbMill and remove the access panel. Clean sprockets of old grease and re-apply a lithium-based grease to sprocket teeth.
Unplug the ClimbMill and clean the AUTO STOP SENSORS (located under the bottom step) and IR sensor windows on Control Zone with a cotton swab and rubbing
alcohol.
For 7xe consoles, enter service mode and select 'test'. Select 'touch calibration' and then select 'start'. Follow the on-screen prompts and touch the screen where
indicated.

PRODUCT SPECIFICATIONS

Max User Weight
Product Weight
Shipping Weight
Overall Dimensions (L x W x H)*
* Ensure a minimum clearance width of 0.6 meters (24") for access to and passage around MATRIX equipment. Please note, 0.91 meters (36") is the ADA recommended clearance width for
individuals in wheelchairs. Brake system is speed-independent with adjustable resistance.
C7xi ClimbMill C7xe ClimbMill
182 kg / 400 lbs
158 kg / 348 lbs
167 kg / 368 lbs
165 x 85 x 212 cm / 65" x 33.5" x 83.5"
C5x ClimbMill C3xe ClimbMill
155 kg / 335 lbs
167 kg / 368 lbs
FREQUENCY
DAILY
MONTHLY
QUARTERLY
QUARTERLY
QUARTERLY
QUARTERLY
QUARTERLY
QUARTERLY
C3x ClimbMill
11