Digital Plus Baby
GB
Control Video
The Chicco Digital Plus Video Baby Control is a
wireless video surveillance system that ensures
you remain in clear and exclusive contact with your
child indoors and outdoors. The digital technology
used guarantees audio and video reception with a
high level of protection against interference caused
by analog devices. In fact, our baby control units
that use digital technology, constantly monitor
the connection between the units (child and par-
ent) and immediately switch to a new channel as
soon as they detect any interference. The reception
capacity is around 150 metres in good range condi-
tions without any obstacles.
Technological reliability is combined with a modern
design and features that make the equipment very
easy to use. The child unit (with image and sound
transmitter function) is fi tted with a nightlight,
a colour video-camera with 2x optic zoom, an in-
frared illumination system to monitor the child in
the dark and a lullaby function. The video-camera
can be orientated in all directions for optimal focus
shots of the child.
The parent unit (with image and sound receiver
function) allows minders to hear and also view the
baby on the 2.4 inch display, it also runs on a re-
chargeable battery pack, allowing parents greater
freedom of movement.
The parent can also use the practical multi-function
button to set the date, time, alarm/reminder, dis-
play luminosity level and image zoom options.
PACK CONTENTS
- One child unit (with image and sound transmitter
function)
- One parent unit (with image and sound receiver
function)
- two switching mains adaptors
50/60Hz / 9V
- Rechargeable battery pack NiMh 4x 1.2V, 1500
mAh, AA type
- Instruction manual
GENERAL WARNING
• Do not leave any packaging materials (plastic
bags, cardboard boxes, etc.) within the reach of
children as these can be hazardous.
• Before using the devices, make sure that no prod-
ucts or their components are worn or damaged. If
in doubt, do not use the device and contact your
local retailer or qualifi ed experts.
• Never attempt to repair the product, but sim-
ply follow the instructions provided in the
"Troubleshooting" section. Please contact the
Artsana S.p.A. Customer Service regarding all re-
pairs.
• Never open the devices. The child unit (with im-
age and sound transmitter function), the parent
unit (with image and sound receiver function) and
mains adaptors do not contain parts that can be
used by the consumer. Please contact qualifi ed
experts or the Artsana S.p.A. Customer Service if
any faults occur. Opening the devices could cause
an electric shock.
100-240V ~
, 600mA
• The Digital Plus Baby Control Video should not
be used as a medical monitor and is not intended
to replace the supervision of children by adults; it
is designed to provide a way of supporting their
surveillance. All other use is to be considered im-
proper.
• Always place the child unit and parent unit on
a fl at, stable surface, out of children's reach.
Alternatively, the child unit can be fi xed to the
wall using the relative slot and/or the parent unit
can be attached to a belt using the clip on the back
of the unit.
• If you decide to fi x the child unit to the wall using
the slot, make sure the screw is fi xed securely to
the wall using a plastic dowel. It is recommended
to position the child unit so that, if it should fall
down, it can not come into contact with the child.
Lay the mains adaptor power cable so that the
child can not touch or tug it. WARNING: danger
of strangulation for the child and injury if the child
unit falls off the wall.
• Always keep the child unit, the parent unit and
above all the AC/DC mains adaptors out of chil-
dren's reach (the adaptor cables could cause
strangling).
• It is vital to regularly check that the child unit
(with image and sound transmitter function) and
the parent unit (with image and sound receiver
function) are both working properly; in particular
check that the signal is receiving clearly and that
you have not exceeded the maximum foreseen
distance. (Read the instructions and refer to the
section entitled "How to test reception")
• The maximum operating distance is around 150
metres in an open space without obstacles (this
range could be reduced considerably indoors ac-
cording to the environmental situations, the lay-
out of walls and furniture, the presence of metal
structures, electromagnetic fi elds/disturbances
of internal or external origin, reinforced concrete
walls, when rooms are located on different fl oors,
or when the batteries are not charged completely
etc.)
• The transmission channels are selected automati-
cally using the hopping technology. It is not possi-
ble to manually switch the transmission channels.
• When the child unit (with image and sound trans-
mitter function) and/or parent unit (with image
and sound receiver function) are alkaline battery
and/or battery pack powered, the product will
stop operating when the batteries run low. It is
therefore recommended to check the alkaline
battery and/or battery pack status on both units
whenever they are switched on.
• When the child unit (with image and sound trans-
mitter function) and/or the parent unit (with im-
age and sound receiver function) are connected to
the mains adaptors, if the alkaline batteries and/or
the rechargeable battery pack fi tted respectively
on the child unit and the parent unit the product
will stop operating during a power cut if the bat-
teries are low. It is therefore recommended to
always check the alkaline battery and/or battery
pack status on both units whenever the child unit
and parent unit are switched on.
• Never use the child unit (with image and sound
transmitter function), the parent unit (with image
and sound receiver function) and mains adaptors
in positions where they are exposed to weather
elements (rain, sun etc). If the product is used
16