Calling Up Stored Values; Change From Degrees To Fahrenheit; Temperature Compensation Adjustment; Switch Off - SCALESON S240 Instrucciones De Uso

6. How to use your thermometer

6.7 Calling up stored values

When the thermometer is on or off, press the Memory/Mute-sound button to enter Memory mode.
Press this key again to read the 35 memory sets in sequence. If no value is available, „---M" is displayed.
6.8 Umstellen von Grad auf Fahrenheit
Öffnen Sie den Batteriefachdeckel und verwenden Sie den
Kippschalter, um von °C auf °F zu ändern.

6.9 Change from degrees to Fahrenheit

When the thermometer is on, press both the Memory/
Mute-sound button and Measure button for 2-3 seconds to
enter the temperature compensation mode. By pressing the
Memory/Mute-sound button, you can set the temperature from
± 0.0 to ± 2.0.
NOTE: All future temperatures you measure will automatically be
increased by the value you set.

6.10 Switch off

The unit switches off automatically if it is not used for 10 seconds. Or you can press and hold the
Measure button for 5-7 seconds to switch off the unit.
CAUTION:
If the battery is uninstalled or reinstalled, all stored values will be lost.
f
All settings are reset to the default settings when the battery is uninstalled. If you need to adjust the
f
settings, turn on the power and make the new settings.

6.11 Replace the battery

Slide the battery cover along the marked direction. Insert two AAA batteries correctly into the
compartment.
NOTE:
Remove the batteries if the thermometer will not be used for more than two months.
24