Yakima RailGrab 8000140 Instrucción

RAILGRAB TOWER (4X)
LARGE CLAW (4X)
NOTE: RAILGRAB IS SOLD
IN 2 PACKS AND 4 PACKS.
If you have purchased a 2 pack RailGrab
the quantities listed above will be two of
each component rather than four of each
component (wrench excluded).
IMPORTANT WARNING
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO
OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR
TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ
AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION
OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE
AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER.
1033506C-1/27
RailGrab 2/4
SMALL CLAW
(PRE-INSTALLED) (4X)
CROSSBARS
ARE PURCHASED
SEPARATELY.
READ THROUGH THIS ENTIRE INSTRUCTION
BEFORE BEGINNING INSTALLATION!
This product is the base for everything you'll do
with your rack, we want to help you get this right.
WRENCH (1X)
Familiarize yourself with these concepts and
terms, and installation will be a snap.
Throughout this document a time line will show
you where you're at in the process.
Notice the time line at the top of the next page
and throughout these instructions.
END CAP (4X)
CROSSBARS
Part #1033506 Rev.C