Relative Humidity - LaserLiner CondenseSpot Pro Manual De Instrucciones

7
Displaying Min/Max/Avg, Ambient temperature, Dew point temperature
1x
8
Dew point temperature
Dew point temperature is the temperature at which current air conditions would produce condensation.
The CondenseSpot Pro calculates the dew point temperature from ambient temperature, relative humidity
and ambient atmospheric pressure. In combination with the infrared thermometer, thermal bridges are
easily detected. If the temperature of the measured location drops below the dew point, condensation
(water) will form on the surface.
IR-temperature 2.5 °C than dew
point temperature:
bar graph shows no indication.
No condensation.
9

Relative humidity

Relative humidity is indicated in relation to maximum possible humidity (100 %) at which air forms water
vapour. The ability of air to hold water is temperature dependent. Thus humidity is the volume of water
vapour in the air. The range for humidity is 0 ... 100%. 100% = saturation point. Under these conditions for
temperature and atmospheric pressure, air cannot absorb any more water.
Relative humidity is automatically
determined and displayed during
the measurement process.
2x
=> MIN/MAX/AVG = 0
3 sec
IR-temperature equal to dew
point temperature: bar graph
displays 5 segments.
Condensation begins.
When temperature uctuations (± 1 °C) and/or changes to relative
humidity (± 1%) are rapid, the sensor must adapt itself to the new
conditions. An hour-glass with progress bar are displayed during this
stabilisation process. During this process, displayed values are only
approximations. Only after these symbols have switched off is a stable
value presented which represents maximum accuracy.
CondenseSpot Pro
3x 5x
IR-temperature
point temperature: bar graph
displays 10 segments.
Condensation.
2.5 °C than dew
07
GB