1.
Turn the MASTER knob on the amp to the minimum position.
2.
Connect the included AC adapter and power cord.
3.
Connect the DC plug of the AC adapter to the DC 19V jack
on the rear panel of the amp, and then connect the plug of the
power cord to an AC outlet.
4.
Secure the cord with the cord hook on the amp to prevent the
DC plug from being disconnected.
5.
If a bass guitar will be used, connect the cable from the bass
guitar to the INPUT jack.
If an audio player will be used, connect it to the AUX IN jack.
6.
Press the
button until the power indicator lights up and the
amp turns on.
7.
Slowly raise the MASTER knob to adjust the overall volume.
Auto power-off function
The amp has an auto power-off function. With this function, the
amp automatically turns off if there is no operation or input for ap-
proximately 4 hours. When the amp turns off, operating a knob or
switch does not turn it back on. After the amp is turns off, turn it
on again.
The auto power-off function cannot be disabled.
When there is input only to the AUX IN jack or when the input
level to the INPUT jack is extremely low, the auto power-off
function may be activated.
Depending on the settings and environment, the amp may inter-
pret noise as input, even if there is no performance, and the auto
power-off function may not be activated.
Setup
Specifications
Input/output jacks:
INPUT : 1/4" phone jack (unbalanced)
AUX IN : 1/8" stereo mini phone jack
DIRECT OUT : TRS phone jack (balanced)
(Headphones) : 1/8" stereo mini phone jack
Valve:
Nutube 6P1
Equalizer:
BASS:
±10dB@90Hz
LO MID:
±8dB@300Hz
HI MID:
±10dB@700Hz
TREBLE:
±10dB@3.2kHz
Output Power:
Maximum approx. 50W RMS
Speaker:
VOX Original 8" speaker
Power supply:
AC adapter (DC 19V
Current consumption:
3.42A
Dimensions (W x D x H):
354 mm × 208mm × 313mm / 13.94"× 8.19" × 12.32"
Weight:
4.5 kg / 9.92 lbs.
Included items:
AC adapter (DC 19V
* Specifications and appearance are subject to change with-
out notice for improvement.
8
)
), Power cord, Owner's Manual