Sauder Craft Pro 417047 Manual Del Usuario página 19

Step 15
Carefully stand your unit upright.
å
Separate the LARGE EXTENSION SLIDES from the LARGE EXTENSION RAILS as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten the LARGE EXTENSION RAILS (12) to the TRAY FRONT (G) and TRAY BACK (I). Use twelve SILVER 1/2" FLAT
å
HEAD SCREWS (9).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the TRAY FRONT and
TRAY BACK. Turn a SCREW into those holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
SILVER 1/2" FLAT HEAD SCREW
(12 used in this step)
417047
LARGE EXTENSION SLIDE
12
9
www.sauder.com
Push up on the black lever and pull the SLIDE from the RAIL.
G
12
LARGE EXTENSION RAIL
12
I
12
Page 19