Publicidad
Step 2
Fasten the SMALL EXTENSION SLIDES and RAILS (11)
å
to the ENDS (B1 and B2). Use twelve SILVER 1/2" FLAT
HEAD SCREWS (9). Use the center hole in each set of
three holes in the SLIDE and RAIL as shown to the right.
NOTE: You will need to extend the SMALL EXTENSION
å
SLIDE and RAIL all the way open to fi nd the center hole in
two of the sets of three holes. Then, slide the large portion
of the SLIDE and RAIL in to fi nd the last center hole in
each SLIDE and RAIL.
Page 6
B1
11
11
Small section of the EXTENSION SLIDE
and RAIL. Use the center hole in each set.
SILVER 1/2" FLAT HEAD SCREW
(12 used in this step)
B2
www.sauder.com
9
SILVER 1/2" FLAT HEAD SCREW
9
11
Remember:
Righty tighty.
Lefty loosey.
11
417047
Publicidad
