Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety, performance, and dependability have been given
top priority in the design of your charger.
INTENDED USE
This charger is only intended to charge Ryobi ONE+ battery
packs listed in this manual.
The product is only for use indoors in dry conditions.
The product is not intended to charge any other type of
battery or be used as a power supply or any other purpose.
It should never be used in explosive or infl ammable
environments.
CHARGER SAFETY WARNINGS
Please read and observe these instructions before using the
product. Failure to follow these instructions and warnings
increases the risk of electric shock, fi re and explosion.
WARNING
Do not recharge primary cells (non-rechargeable).
WARNING
Mains voltage must correspond with the voltage
specifi cations on the product.
■
Before using the product, check that the product
enclosure, cable and adaptor plug are not damaged.
If damage is found, do not use and follow instruction in
the maintenance section of this manual.
■
The product must not be damp, and should never be
used in a damp environment.
■
The product is for indoor use only.
■
Do not use the product if it has suffered any heavy
shock or jolting, or is damaged in any other way.
■
Do not conduct charging in a position which may
become exposed to sunlight or other heat source.
Recommended temperature range at charging vicinity
is 10° to 25° C.
■
Due to the heat generated during charging, the product
should not be operated on a combustible surface.
■
Do not conduct charging operations in the vicinity
of flammable materials. Example: Cloth, packaging
materials, paint, spray paint or aerosols, lubricant,
thinners, petrol containers, gas containers or gas
appliances.
■
Do not cover any ventilating slots and provide adequate
ventilation during operation.
■
Never modify, disassemble or attempt to repair the
product yourself.
■
Do not allow the charger or batteries to become
contaminated with any material which could be
conductive. Example: Metal particles from grinding,
cutting or machining processes.
■
Remove the plug of the product from the power socket
when it is not in use or when cleaning it.
■
Only use extension cable that is approved and in good
condition.
■
Protect battery contacts to avoid a short circuit caused
by metallic objects which could cause a fire or explosion!
■
Do not charge batteries which show signs they have
leaked electrolyte. Dispose of them properly.
■
Never charge a damaged battery pack. If damaged,
replace immediately.
■
If the battery is not going to be used for a while, remove
the charger plug from the power socket and take the
battery off the product.
KNOW YOUR PRODUCT
See page 77.
1. Battery port
2. Red LED
3. Green LED
4. Key hole hanger
MAINTENANCE
■
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
■
Remove the plug of the product from the power socket
when it is not in use or when cleaning it.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloth or soft brush to remove dirt, dust, etc.
■
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
WARNING
Hazardous voltages are present within this product; do
not disassemble.
■
There are no user service or replacement parts inside
this product. In case of damage or failure please return
to your authorised Ryobi service centre for professional
repair.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
UK
English |
1
Publicidad
Tabla de contenido
