The table below summarises the rigging parts or kits required for various applications, and some examples of the possible rigging options are illustrated.
TCS series cabinets are designed with multiple internal rigging points to suit many possible mounting methods in permanent installations. All cabinets can be simply
suspended using optional M8 or M10 shoulder eyebolts coupled to the internal rigging points provided. Remove the appropriate countersunk screws and replace them
LF
with eyebolts, which must have a thread length of at least 18mm. Use the rear rigging point to angle the cabinet for optimum room coverage. Cabinets may be hung
upside down if required. Turbosound WB-20, WB-55 and CB-55 wall and ceiling brackets are optionally available for TCS series cabinets, and these are also compatible
with OmniMount* wall and ceiling brackets which use 60 mm x 60 mm hole spacing.
Model
Wall
WB-20
TCS62
TCS62-SB
TCS122
WB-55
TCS152
WB-55
TCS115B
TCS Subwoofers
Some typical examples of the possible rigging options are shown here: